Add felt, if needed, before nailing the new wood on, and prime the new wood on all four sides before installing it. Repair Siding: Use a Kick-Out Flashing to Stop Rot. Install undersill trim along the edge of the vinyl, over the flashing at the top and bottom. When flashing a structure constructed with pressure treated lumber, DuraFlash is the real solution in protecting your investment. Next, slide drip flashing behind the vinyl so the lip fits over the top of the ledger as shown at right. Then tack the ledger into place with 16d nails. Nail J-channel along both sides of the cutout. Provides corrosion resistance for added safety. Keep water out from behind your deck frame by using this DuraFlash Tan Vinyl Deck Flashing. White Vinyl Deck Flashing resists corrosion and will not react with the chemicals in pressure-treated lumber. Whether you have wood, vinyl or aluminum siding, you can avoid this by oversizing the ledger board and creating space for water to run off. White Vinyl Deck Flashing - The Home Depot The DuraFlash 10 in. Builders avoid rot by installing flashing along the top edge of the ledger board, but even when this is done according to accepted practices, it creates a pocket for debris to collect, and this can rot the decking board closest to the house. Attaching a deck to your house creates the potential for rot, not only to the ledger board that you attach to the house to support the deck, but to the house framing.
0 Comments
Leave a Reply. |